0800 500 407

 
Australia

1300 500 407

 
 
 
 

Towing Heads, Duct Pullers & Swivels

Once you use any of the Brewis towing heads / duct pullers, you'll be hooked on the quality. Available in sizes up to a metre in diameter, the Brewis range of towing heads have been the towing workhorse of the industry for the last twenty years.


Brewis standard duct Puller

Brewis Standard Towing Head / Duct Puller


The Brewis standard towing head / duct puller provides a quick and easy way to attach a pulling eye to the end of polyethylene pipe. There are a large range of towing heads available from 32mm diameter to 900mm diameter

Installed and removed in seconds

Proven tooth profile for maximum
grip - the harder the eye is pulled the harder the pipe is gripped

High tensile steel, drop forged eyebolts for superior strength - no welds


Brewis mud tight gold towing head / duct puller

Mud Tight GOLD Sealed Expanding Towing Head / Duct Puller


Designed specifically for the horizontal directional drilling, the mudtight gold towing head gold provides a quick and easy way to attach a pulling eye to the end of polyethylene pipe, and at the same time seal the end of the pipe to keep the inside clean. 32mm to 250mm available ex stock.

Minimal increase in outside diameter means bore size can be kept to a minimum.

Patented seal on inside of the pipes seals both SDR 11 and 17.6

Quick and easy, no cleaning afterwards


Brewis fuse on towing head / duct puller

Brewis Fuse On Towing Heads & Duct Pullers


Brewis fuse on towing heads are machined from solid polyethylene for high strength. They range in size from 63mm to 740mm. The fuse on heads have sealed high tensile drop forged eyebolts for superior attachment and a stepped design at the back for easy butt fusion to either SDR9, SDR11 or 17.6 pipe. (Other SDR's can be made to order.)


Brewis Fuse on towing heads and duct pullers

Brewis Fuse On Towing Heads & Duct Pullers


Brewis fuse on towing heads are machined from solid polyethylene for high strength. They range in size from 63mm to 740mm. The fuse on heads have sealed high tensile drop forged eyebolts for superior attachment and a stepped design at the back for easy butt fusion to either SDR9, SDR11 or 17.6 pipe. (Other SDR's can be made to order.)



Brewis swivel

550 US Ton Swivel

Big Rig HDD Pull Back Swivels


The range of “BIG RIG” swivels are a further development of the famous Brewis Heavy Duty Swivel. Brewis manufacture a multitude of sizes from 44 to 550 US tons in box to clevis or clevis to clevis design. Each swivel uses an SKF Explorer or FAG X-Life spherical roller thrust bearing of a declared size. i.e. The 154 US Ton swivel contains a bearing with a dynamic capacity of 154 US Tons. Most swivel makers don’t declare the bearing capacity of their swivels but instead quote a figure for the strength of the supporting steelwork; this isn’t much help if the bearing has seized!

Manufactured from high tensile 4145 steel.

One piece shaft and Clevis give maximum strength and durability

Side grease point to allow easier power greasing

Patented Sealing system keeps bentonite out but allows power greasing